1.125 in induction hardened chrome shafting. The base material is 1045/1050 Carbon Steel with 0.0005 in (0.0127mm minimum)-thick chrome plating and a case depth of 0.05 in (1.27 mm).
Induction Hardened Chrome is typically used in abrasive envrionments where the cylinder is exposed to rocks or heavy debris. Also used to machine clevis pins.
- Greater strength
- Better resistance to mechanical damage
Packages longer than 44 inches may have additional freight charges.
| 1-14 | $4.03 |
| 15-29 | $2.69 |
| 30-89 | $1.92 |
| 90-134 | $1.49 |
| 135+ | $1.34 |
HT-2500X2000 has a wall thickness of 0.25 in. The ID is 2 in and the OD is 2.5 in. The material is DOM 1026 Steel – ST52.3 and has been stress-relieved and annealed.
Packages longer than 44 inches may have additional freight charges.
| 1-14 | $3.89 |
| 15-59 | $3.34 |
| 60-104 | $2.92 |
| 105-149 | $2.59 |
| 150+ | $2.34 |
Machined from 1018 Carbon Steel for a 2 in cylinder.
The length is 0.5 in and the lip is 0.25 in in tall.
Base plates are welded to the end of the cylinder opposite the rod end to secure the cylinder. They provide a solid support for the entire cylinder base area.
Cast Iron Rod Clevis Mount with a 0.75 in – 16 TPI threaded end and a 0.75 in pin hole.
Clevis mounts help maintain alignment and protect the cylinder from side load. Mounts attach to threaded stud ends, pivot holes, or bolt holes on the cylinder. Can be used with hydraulic cylinders with standard bore sizes.