Snap-in Wipers for Sale | CRC Distribution

AN wipers are ideal for light duty and pneumatic applications. Its main purpose is to prevent dirt and contaminants from entering the hydraulic or pneumatic systems.

AN wipers will retrofit into glands prescribed in MS-33675 for corresponding dash numbers of MS-28776.

• Flexible, snap-in design for easy installation into closed housings
• Low compression set

RW-80XNBR-5/8×15/16×0.194

The outside diameter of the ring has a crush lip providing extra interference in the groove. A bead on the shoulder stops contaminates from entering through the groove. The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal.

ST-XL (Hallite 520) wipers are direct replacements for ST or D wipers.

• Crush lip to provide extra interference
• Bead on the shoulder to keep contaminants out
• Ribbed ID to prevent pressure traps

RW-93URE-20.00×26.00×3.80 (4.00)

RW-94URE-38.00×46.00×3.60

The Hallite 38 single-lipped polyester wiper/scraper is designed to fit metric housings including those of ISO 6195A. Suitable for heavy duty applications.

The proportions of the wiping lip ensure that contact is maintained with the surface of the rod to remove heavily deposited containments such as mud and ice.

The outside diameter of the wiper incorporates a crush lip to provide an interference fit with the housing. This feature helps prevent contamination from entering the groove.

The Hallite 38 wiper is molded in a polyester-based material to provide a tough, abrasionresistant wiper for the difficult conditions usually found in mining or earth moving applications.

• Crush lip design provides effective seal on housing
• Ribs relieve pressure and improve stability
• Effective scraping lip to scrape off heavily deposited containments including ice

Light duty, polyurethane wiper with a double-stepped shoulder to fit tightly into the gland throat.

• Double-stepped shoulder

RW-90FKM-1.500×1.875×0.188

The outside diameter of the ring has a crush lip providing extra interference in the groove. A bead on the shoulder stops contaminates from entering through the groove. The inside diameter is ribbed to prevent pressure traps between the wiper and rod seal.

ST-XL (Hallite 520) wipers are direct replacements for ST or D wipers.

• Crush lip to provide extra interference
• Bead on the shoulder to keep contaminants out
• Ribbed ID to prevent pressure traps

RW-92URE-25.00X31.00X3.60/4.80